WTD: Idle Adjust Screw

[Fader]

Cmon guys we still need one! someone out there must have a spare engine sitting around with an idle adjust screw in it!! it will fit in an envelope!

You dont even wanna know how i have it set up at the moment! its ugly! real ugly!

Thanks
Chris

[Colza]

Ya know? It just so happens that i picked up a new throttle body the other day. And that i wont be using the autochoke on it cos i already have one that works fine. So that would mean that i might just happen to have an idle adjust screw going spare...


Its a wee bit toight at the moment, but ill give it a soak in some CRC and see how it comes out

[Fader]

Mate that would be AWESOME! if you can get it out without too much breaking!

THANK YOU!!

let me know how you got with it!

[Colza]

Hmmm, did not go as well as i had planned. Sadly Mr. Idle Screw had to be introduced to Mr. Impact Driver :-/ however all is not lost. It is still in one piece and has most of its top there...




Hmmm, they are a tad bigger than i had planned, but whos to complain

[Fader]

Mate, that looks a lot better than my effort!!

i have the springs and washers and all that, so if you want to keep them feel free, but if you dont need them, just chuck them in with the screw.

if you could post that we would be most grateful, pm brendan about payments and address' etc.

Thanks again!!
Chris

[Colza]

Posted this morning. Only the screw im afraid because it was only just under the width limit as it was. Good luck

[Fader]

Thanks mate thats fantastic!

You get special treatment from now on! Anyone mess' with colza, mess' with me. Got it?

;D