Honda city parts WA
-
- I'm New Here, Please Be Nice!
- Posts: 9
- Joined: Thu Aug 15, 2013 9:40 pm
Honda city parts WA
Hey everyone I have a honda city t1 and I'm searching for a few parts for it. Does anyone have a top engine mount, front lower ball joints (left and right) and both outer cv joints or whole shafts? Thanks
-
- I'm New Here, Please Be Nice!
- Posts: 9
- Joined: Thu Aug 15, 2013 9:40 pm
Re: Honda city parts WA
Any help would be appreciated thanks. Called up a few places and no luck. Only sourced some tie rod ends for now. Still needing lower ball joints for the front and the torque mount that that you can see from the top of the engine.
-
- I'm New Here, Please Be Nice!
- Posts: 9
- Joined: Thu Aug 15, 2013 9:40 pm
Re: Honda city parts WA
Still looking for front lower control arms for a 1983 city turbo 1. If anyone has any laying around or even a wreck please pm me. Thank you
-
- I'm New Here, Please Be Nice!
- Posts: 6
- Joined: Mon Aug 12, 2013 11:59 pm
- Location: Bunbury W.A
- Contact:
Re: Honda city parts WA
Hey mate did you buy that T1 from Del in Mandurah ? Sweet little car.
-
- Forum Regular
- Posts: 78
- Joined: Wed May 01, 2002 4:46 am
- Location: Perth, Western Australia
- Contact:
Re: Honda city parts WA
A loose top engine mount (the rubber shrinks over time apparently) can be fixed by wraping some vaccum hose around it, I used some welding rod to keep the ends together (to make an O ring of sorts) while I squeezed it into place. A little soap works as lube. Better than new
There's a solution to the lower ball joints on the forum if you search hard enough. Any decent suspension shop should be able to replace them too.
There's a solution to the lower ball joints on the forum if you search hard enough. Any decent suspension shop should be able to replace them too.
-
- I'm New Here, Please Be Nice!
- Posts: 9
- Joined: Thu Aug 15, 2013 9:40 pm
Re: Honda city parts WA
MUnity wrote:A loose top engine mount (the rubber shrinks over time apparently) can be fixed by wraping some vaccum hose around it, I used some welding rod to keep the ends together (to make an O ring of sorts) while I squeezed it into place. A little soap works as lube. Better than new
There's a solution to the lower ball joints on the forum if you search hard enough. Any decent suspension shop should be able to replace them too.
yeah i ended up pulling it out and filling the gaps with sika flex. workes a treat. with the balljoints there too far gone to be repaired and there the balljoints which are welded into the control arms. ive ask around alot of suspension shops but they all seem to have no interest.
-
- I'm New Here, Please Be Nice!
- Posts: 9
- Joined: Thu Aug 15, 2013 9:40 pm
Re: Honda city parts WA
Krgracing wrote:Hey mate did you buy that T1 from Del in Mandurah ? Sweet little car.
yeah i did. its alot different and has come along way already since i took it off her hands. awesome car haha
Who is online
Users browsing this forum: No registered users and 31 guests