Page 1 of 1

Bits for RWC (86 Turbo II)

Posted: Wed May 24, 2017 3:31 pm
by vinnytang
Hey guys,

My new car went through its first roadworthy test after my drive down from the Central Coast to Melbourne to grab her.

Thankfully, the list to get her over the line is fairly small.

Hunting for the following parts, maybe someone might know if there are repco/generic parts that could work?

- Pedal rubbers
- CV Boots
- Reverse light switch
- Rear main seal
- crankshaft seal

Thanks in advance for any help. This car is so close to being back on the road!

Re: Bits for RWC (86 Turbo II)

Posted: Mon May 29, 2017 7:00 am
by James
CV boots should be readily available.
Reverse light switch you might have to pull from another gearbox, I have several spare if you get stuck.
Oil seals should be relatively easy to get. They are just standard oil seals.

If you check here:

http://www.lingshondaparts.com/honda_ca ... ock_05=hcr

You can see you need a OIL SEAL, 35X50X8, and a OIL SEAL, 74X98X12. which if you google leads you to:
http://www.butlerautomart.co.nz/our-ran ... J242N.aspx
http://www.butlerautomart.co.nz/our-ran ... NJ073.aspx

Re: Bits for RWC (86 Turbo II)

Posted: Tue May 30, 2017 3:05 pm
by vinnytang
Thanks for the response James, the car is now roadworthy. Going for plates later this week, then the fun begins!

Re: Bits for RWC (86 Turbo II)

Posted: Tue May 30, 2017 6:41 pm
by James
Good work! We need to keep more of these on the road :)