Page 1 of 1
T1 parts required
Posted: Thu Mar 20, 2003 1:57 pm
by gen1hybrid
Howdy.
Im looking for the following parts if anyone can help......
MAP sensor control box and a loom.
Cheers
Darcy
Re: T1 parts required
Posted: Fri Mar 21, 2003 12:21 am
by kenny
what does the MAP sensor control box look like?? might have one.
thanks kenny
Re: T1 parts required
Posted: Fri Mar 21, 2003 5:19 pm
by BOOSTBOY
The big black box at the rear drivers corner of the engine bay with all the hoses going into it... :)
Re: T1 parts required
Posted: Tue Mar 25, 2003 1:53 pm
by JohnT
The MAP sensors themselves are the two black square looking devices with three wires going into each, that are mounted inside the metal tray with all the vacuum hoses going in. (about 3 cm * 3 cm * 2 deep) Round plugs (one white, one green) on the MAP sensors.
You also need the trim resistor that has again three wires coming from a squarish plug, this is a round devide that is again screw mounted in the metal tray. There is an adjusting screw inside this which drives a ??mixture?? setting.
The rest of the gear inside that metal tray isn't essential, although it is good to have an idle up solenoid, but they are a dime a dozen from the wreckers - Honda used to use them all over the place.
John