Hey all, can anyone tell me the distance between the studs on the turbo side of the manifold prob middle of the stud to middle. I have a 2nd turbo for the car and want to know how close its going to be from bolting straight up. I dont really want to have to take turbo off just to see if it will fit yet.
Thanks
T2 Turbo Manifold
-
- Donating Member
- Posts: 162
- Joined: Sun Jan 01, 2006 4:26 pm
- Location: Adelaide South Australia
Thanks Bigelboe, i have a feeling it might go close to bolting straight up. This is one of my mazda 12A turbo's that i have in good nick and could be a great upgrade for more T2's as these turbo's are easy to get, most rotary places throw them away as they are small for a mazda. At 7.5psi they only make 165hp on a 12AT hmmm the T2 would RIP with 165hp .
- James
- Moderator / Donating Member
- Posts: 3092
- Joined: Wed Apr 09, 2003 1:59 pm
- Location: Putaruru
- Contact:
If they are designed to flow 165Hp of air at 7.5 PSI its going to be well off its efficiency map at the sort of boost required to get that sort of power out of a T2, your going to need like 18+psi out of it probably to get that power, and your going to want to run at least 15psi to make it fun, and thats twice the factory boost.
This is the trouble we get into with finding turbos for our cars, because they need to run such high boost levels, very few factory turbo compressors are designed to work efficiently at that sort of airflow.
But hey if its a bolt up then give it a go
This is the trouble we get into with finding turbos for our cars, because they need to run such high boost levels, very few factory turbo compressors are designed to work efficiently at that sort of airflow.
But hey if its a bolt up then give it a go
Who is online
Users browsing this forum: No registered users and 42 guests