please please please fit!!!

[city_racer]

hello i found these wheels and tyres and the specs were

Alloys 4 x 100 PCD, et35 Offset, 57mm centre bore

Tyres 195/65/14

would these fit?
how well?

thanks

[QikLude]

correct pcd, offset is ok i think?

Cheers

[James]

That is about 5-10mm on the low side for offset, they might rub like a bastard in the back. But they are 14"s so I dont really know. How wider are the rims?

[city_racer]

so they would fit the front? and rub like a bastard on the back? is there any way to stop the rubbing like a bastard bit ? they have slicks on them so would be exposed to g forces.....any difference? umm i'll get back to you with the rim width

thanks again

[city_racer]

6" inch wide....and he had them on a golf gti.

[Colza]

Low offset means they will stick out further. Your solution is to roll the guards or cut them back and fit some flares.

[city_racer]

so would it rub like a bastard if they are sticking out more?

[James]

You might just be ok or they might rub, I don't have enough experience with cities to say for certain.

If they rub there are a few options, you can get a panel hammer and a baseball bat and roll the back guards out a bit. or you could get a few mm milled of the hub mating surface or two or all of the mags.