Hi All,
I have a T1 that seems to be missing something from the end of the red casting that says pgm-FI. In the pic below it is where the brass fitting is. The brass fitting does not look correct to me - looks like something from bunnings.
When I drove it home, it suddenly lost power and after checking - the plug that they had whacked over that fitting had blown out so no boost (I think)...
Anyhow, I have put a WTB in the classies but just hoping someone can tell me what should be there or show me a picture of an original setup so I can narrow down the search.
Can anyone tell me what goes here on my T1 engine?
-
- Moderator / Donating Member
- Posts: 1217
- Joined: Sat Feb 21, 2004 9:31 am
- Location: Christchurch, New Zealand
Normally there is no hole there, so it looks like someone has added the fitting (i'm guessing to connect up a blow off valve) by making a hole.
Best option is to find something to block the fitting with.
Edit: just looked at the workshop manual, it does show a fitting there but not enough detail to make out.
Either way it should be blocked.
Best option is to find something to block the fitting with.
Edit: just looked at the workshop manual, it does show a fitting there but not enough detail to make out.
Either way it should be blocked.
Who is online
Users browsing this forum: No registered users and 59 guests