Page 1 of 1

Sard Electronic Boost Controller

Posted: Wed Dec 28, 2016 1:08 pm
by Sander
Hey guys,
I've purchased a Sard "trigger" two stage boost controller.
I've been reading up a bit using the search (so don't fry my ass lol).
My question is, can I tap into the wastegate hose number 32 that goes to the infamous black box?
I'm thinking of using that hose to go in and out of the controller unit and then on to the black box but i don't know if it'll affect the sensor #32 is hooked up to.
any thoughts?\
tia
Sander

Re: Sard Electronic Boost Controller

Posted: Thu Dec 29, 2016 6:07 pm
by KingCity
You could try that but it will depend on the boost controller which im sure needs in & out hoses fitted to work properly. The correct way would be to unplug & block No32 hose from wastegate actuator & the one on the actuator, then disconnect the other hose from the actuator to the turbo & link your boost controller solenoid/bleed valve between them making sure you get the flow direction correct (1 from turbo to solenoid, the other from solenoid to wastergate. T1's only have 1 hose from turbo to actuator where as T2 uses line 32 for its factory boost controller.

Re: Sard Electronic Boost Controller

Posted: Fri Dec 30, 2016 1:50 am
by Sander
Cheers for that mate,will give it a go.
It has an IN and OUT port so should be good.
Image

Re: Sard Electronic Boost Controller

Posted: Fri Dec 30, 2016 5:12 pm
by KingCity
No worries, once you see the turbo & hosing u'll work it out in no time, all the best.