yeah, i would love the torque settings for most of the important bolts as well
Any idea where to find that?
Are they the same as all other ER motors?
Jw
Honda City Turbo 1
-
- Forum Addict
- Posts: 609
- Joined: Mon Mar 03, 2003 11:50 am
- Location: christchurch, NEW ZEALAND!!
- Contact:
Re: Honda City Turbo 1
torque for head is best at 60-65 lb ft. big ends at 45.
2 stripes on camshaft wheel - must lie in line with the top edge of the head. make sure that no 1 is on the rock.
tdc is the T mark OK. then set up belt. Dizzy has a dot on the base cog (little bump between the split pin) and little triangle on dizzy shaft. line up and insert.it will turn.it can be hard to make the right cog fit but the dizzy pickup and 4 lobed thingy should be about 1mm from touching with the dizzy in the centre of its adjustment. rotor sparking edge should be pointing towards the front of the car but it doesnt point straight ahead.
mmmkay?
2 stripes on camshaft wheel - must lie in line with the top edge of the head. make sure that no 1 is on the rock.
tdc is the T mark OK. then set up belt. Dizzy has a dot on the base cog (little bump between the split pin) and little triangle on dizzy shaft. line up and insert.it will turn.it can be hard to make the right cog fit but the dizzy pickup and 4 lobed thingy should be about 1mm from touching with the dizzy in the centre of its adjustment. rotor sparking edge should be pointing towards the front of the car but it doesnt point straight ahead.
mmmkay?
Who is online
Users browsing this forum: No registered users and 221 guests