Lads... The cage was made by a cams approved roll cage fabricator here in Adelaide.
It was custom made for my city T2, as nobody has ever bothered to make a roll-cage for one of these car here...
Measurements where taken for the design to be made & supplied as a "kit" for lack of better words.
All the tubes are pre bent & ruffly cut to length. This cost $950 alone.
Now I've got the task of cutting & notching the tubes to fit correctly together, followed by welding the lot in myself. Then submitting the photos & papers work to CAMS for approval.
To have the complete job done including welding, it was quoted at around $2600-3k
So are you still interested now!?
I could supply one of these "KITS" to you interstate, but you would NOT get any change out of $1000 (including shipping)