Howdy.
Im looking for the following parts if anyone can help......
MAP sensor control box and a loom.
Cheers
Darcy
T1 parts required
Re: T1 parts required
what does the MAP sensor control box look like?? might have one.
thanks kenny
thanks kenny
Re: T1 parts required
The big black box at the rear drivers corner of the engine bay with all the hoses going into it... :)
- JohnT
- Donating Member
- Posts: 177
- Joined: Sat Aug 10, 2002 6:16 pm
- Location: Adelaide South Australia
Re: T1 parts required
The MAP sensors themselves are the two black square looking devices with three wires going into each, that are mounted inside the metal tray with all the vacuum hoses going in. (about 3 cm * 3 cm * 2 deep) Round plugs (one white, one green) on the MAP sensors.
You also need the trim resistor that has again three wires coming from a squarish plug, this is a round devide that is again screw mounted in the metal tray. There is an adjusting screw inside this which drives a ??mixture?? setting.
The rest of the gear inside that metal tray isn't essential, although it is good to have an idle up solenoid, but they are a dime a dozen from the wreckers - Honda used to use them all over the place.
John
You also need the trim resistor that has again three wires coming from a squarish plug, this is a round devide that is again screw mounted in the metal tray. There is an adjusting screw inside this which drives a ??mixture?? setting.
The rest of the gear inside that metal tray isn't essential, although it is good to have an idle up solenoid, but they are a dime a dozen from the wreckers - Honda used to use them all over the place.
John
Who is online
Users browsing this forum: No registered users and 28 guests