turbolocodude
Posted: Thu Aug 18, 2016 2:36 am
http://i.imgur.com/KDqo7Klh.jpg
http://i.imgur.com/eps2jEDh.jpg
http://i.imgur.com/VVwdE5ih.jpg
http://i.imgur.com/Wx1OrYDh.jpgAfter over a year owning this car I finally posted it. I have wanted one of these cars since I was 13 years old. It all started with a radio controlled Tamiya Willy's Wheeler I built in 1986 but that was a turbo 1 racing. My car is a right hand drive 1984 Turbo 2 that I found on Craigslist over a year ago. The car had a bad stumble due to fuel starvation. The fuel tank had to be cleaned. It was full of rust flakes. New fuel pump installed. One of the fuel lines was kinked at the pump. made a 180 degree pipe solved that issue. Fuel filter was replaced. All 5 injectors were sent out to get cleaned. The distributor vacume advance diaphram was perished. Sent to a local rebuilder and a new diaphram was crimped in. I took apart cleaned and lubed the centrifugal mechanism. I made a air filter out of mesh and filter element. Changed the spark plugs. Did an oil change with filter. Adjusted the clutch freeplay. On my first test drive it had that anoyying 100 kph chime that drove me crazy on that drive to work on the freeway. You guys here helped me solve that issue by clippin the wire to buzzer. Thanks again Dudes! I new a friend that had these mesh wheels sitting aroud for years in storage. I was able to purchase them for $150 with 205/60/13 GT Lops with the raised lettering. The wheels are vintage 80's Caroll Shelby Super Mesh (CSSM) 13 x 6 but the bolt pattern was meant for a first gen Mazda RX7 4 x 104 I had a wheel machine shop weld and redrill to 4 x 100 also the offset was too deep so the back side of the wheels were shaved 3/4 inch, the snout where the center cap would be was also shaved and the face and lip were polished. Tires 185/60/13 still slightly rub when it hits a bump. Driver and passenger seats are not factory 90's crv. I just purchased a pair of 91 CRX civic seats found on craigslist for $170 that will be reuphostered to color mach the back seat blue and grey. If you notice my use of terms and lingo My car is in Los Angeles, California, USA. I think there is another Honda City Turbo in, San Diego. Maby only 10 Honda City's in USA.
http://i.imgur.com/eps2jEDh.jpg
http://i.imgur.com/VVwdE5ih.jpg
http://i.imgur.com/Wx1OrYDh.jpgAfter over a year owning this car I finally posted it. I have wanted one of these cars since I was 13 years old. It all started with a radio controlled Tamiya Willy's Wheeler I built in 1986 but that was a turbo 1 racing. My car is a right hand drive 1984 Turbo 2 that I found on Craigslist over a year ago. The car had a bad stumble due to fuel starvation. The fuel tank had to be cleaned. It was full of rust flakes. New fuel pump installed. One of the fuel lines was kinked at the pump. made a 180 degree pipe solved that issue. Fuel filter was replaced. All 5 injectors were sent out to get cleaned. The distributor vacume advance diaphram was perished. Sent to a local rebuilder and a new diaphram was crimped in. I took apart cleaned and lubed the centrifugal mechanism. I made a air filter out of mesh and filter element. Changed the spark plugs. Did an oil change with filter. Adjusted the clutch freeplay. On my first test drive it had that anoyying 100 kph chime that drove me crazy on that drive to work on the freeway. You guys here helped me solve that issue by clippin the wire to buzzer. Thanks again Dudes! I new a friend that had these mesh wheels sitting aroud for years in storage. I was able to purchase them for $150 with 205/60/13 GT Lops with the raised lettering. The wheels are vintage 80's Caroll Shelby Super Mesh (CSSM) 13 x 6 but the bolt pattern was meant for a first gen Mazda RX7 4 x 104 I had a wheel machine shop weld and redrill to 4 x 100 also the offset was too deep so the back side of the wheels were shaved 3/4 inch, the snout where the center cap would be was also shaved and the face and lip were polished. Tires 185/60/13 still slightly rub when it hits a bump. Driver and passenger seats are not factory 90's crv. I just purchased a pair of 91 CRX civic seats found on craigslist for $170 that will be reuphostered to color mach the back seat blue and grey. If you notice my use of terms and lingo My car is in Los Angeles, California, USA. I think there is another Honda City Turbo in, San Diego. Maby only 10 Honda City's in USA.